Hoover FREESPACE TFS 5206 Manual De Instrucciones página 7

Freespace_bag_std t7.qxp
Parking and storage - The telescopic tube can be parked for temporary storage
during cleaning or in the storage position when not in use (P13 & P14).
CLEANER MAINTENANCE:
Replacing the dust bag (depending on model) - If the bag check indicator is
illuminated (P15) please check and, if necessary, replace the dust bag.
1. Remove the hose from the cleaner (P1).
2. Press buttons on handle (P16) and remove the bag door (P17).
3. Pull the bag collar to remove the dust bag (P18) and carefully dispose of the bag
into a bin.
4. Fit a new bag into the cleaner by inserting the bag collar into the bag holder.
Important: The hose must be removed before removing or replacing the dust bag.
Remember: The bag check indicator will also illuminate if an obstruction has occurred.
In this case refer to the section "Removing a blockage from the system".
Emptying the permanent dust bag (depending on model) - If the bag check
indicator is illuminated (P15) please check and if necessary, empty the permanent
dust bag.
1. Remove the hose from the cleaner (P1).
2. Press buttons on handle (P16) and remove the bag door (P17).
3. Pull the bag collar to remove the dust bag (P18) from the cleaner.
4. Remove the plastic guide at the end of the bag allowing dirt collected to fall into
the bin (P19).
5. Return the guide back into the original position.
6. Replace the permanent dust bag by inserting the bag collar into the bag holder.
7. Check the filters for excessive build up of dust and if necessary clean the
washable filter (see 'Cleaning the washable filters').
Removing the pre-motor and exhaust filters
To remove the Hepa pre-motor filter (depending on model):
1. Open the bag door and remove the dust bag from the cleaner (see 'Replacing the
dust bag').
2. Press the latch at the top of the Hepa pre-motor filter frame to unlock it from the
cleaner. Tilt then remove the filter from the cleaner (P20).
To remove the Purefilt pre-motor filter (depending on model):
1. Open the bag door and remove the dust bag from the cleaner (see 'Replacing The
Dust Bag').
2. Pull the tabs on the filter grille to remove it from the main body of the cleaner
(P21).
3. Remove the washable Purefilt pre-motor filter from the filter grille (P22).
09/02/2007 16:52 Page 3
3
GB