Troubleshooting - ARIETE 2770 Manual De Instrucciones

EN
How to empty the dust container (A)
IMPORTANT: Clean the dust container (A) and filter (C) in good time; suction power will be reduced
if the container is full or the filter is clogged.
- Remove the handheld cleaner, as described previously.
- Press the release button (D) and pull out the whole container (Fig. 10).
- Pull out the filter (C) (Fig. 11) and the relevant filter support (B) (Fig. 12) and clean them.
IMPORTANT: Only wash the filter (C) in clean water, without using soap or detergent.
- Empty the dust out from the container (A) and into a plastic bag; if necessary, rinse out the con-
tainer.
- Dry all parts and then refit them.
IMPORTANT: Correctly fit the support (B), filter (C), and dust container (A) before switching on the
appliance.
- Fit the whole container to the power base (H), pushing it down until it clicks into place (Fig. 13).
How to clean the floor brush (T)
IMPORTANT: Only clean the floor brush (T) after removing it from the appliance.
- Push the release lever forwards and remove the plastic cover (Fig. 14).
- Take out the rotating brush (Fig. 15) and then clean it and refit it correctly.
- Fit the plastic cover in place, pushing back the special lever (Fig. 16).

TROUBLESHOOTING

Problem
The motor is not working
Suction power becomes
weak
The charge indicator light
doesn't work
The battery use time is shor-
ter and shorter
Possible reason
Flat battery
The dust container is full or the
filter is blocked
Power supply disconnected
Charger plug not firmly inserted
There is dust between the motor
electrode and the base
If the battery is fully charged
within 16 hours
- 12 -
Solution
Recharge the battery
Empty the dust container and
clean the filter
Plug back in firmly
Clean off the dust
If the battery can only work for
1-2 minutes after a full 16-hour
charge, it may be flat and sim-
ply needs replacing with a new
one.