Cleaning And Sanitizing Procedures - Cecilware 8/1 Manual De Instrucciones

heating source is close to the unit and air flow
through the slotted panels is not obstructed by
wall or boxes. Allow at least 15 cm (6") of free
clearance all around the dispenser.
In any case if the product in the bowls is cold the
unit is running properly.
5
How to reset beverage temperature:to reset
b e v e r a g e t e m pe r a t u r e p l e a s e ap p l y t o a
technician.
The proper temperature is preset at the factory.
5. 3 CLEANING AND SANITIZING
PROCEDURES
Cleaning and sanitizing of the dispenser are
recommended to guarantee the conservation
of the best product taste and the highest unit
efficiency. This section is a procedural
g u i d e l i n e o n l y a n d i s s u b j e c t t o t h e
requirements of the local Health Authorities.
Prior to the disassembly and cleaning, the
machine must be emptied of product.
5. 3. 1 DISASSEMBLY
ATTENTION
Before any disassembly
procedure make sure that the dispenser is
disconnected from
unplugging it or switching off the 2-pole wall
breaker.
1
Remove cover from the bowl.
2
Remove the empty bowl by lifting first its
front side (faucet side) up and off bowl gasket
(see figure 1).
figure 1
3
Remove the bowl gasket.
4
Remove the pump impeller from its location.
and/or cleaning
its power source by
5
Gravity faucet: extract the piston and then
remove the dispensing handle (see figure 2).
6
Slide drip tray out and empty it.
5. 3. 2 CLEANING
IMPORTANT
Do not attempt to wash any machine components
in a dishwasher.
ATTENTION
Before any disassembly
procedure make sure that the dispenser is
disconnected from its power source.
1
Prepare at least two gallons of a mild
cleaning solution of warm (45-60 °C 120-140 °F)
potable water and dishwashing detergent. Do not
use abrasive detergent.
Important: if present, follow label directions, as
too strong a solution can cause parts damage,
while too mi ld a solution will not provide
adequate cleaning.
IMPORTANT
In order to prevent any damages to the dispenser
use only a detergent suitable with plastic parts.
2
Using a brush, suitable for the purpose,
thoroughly clean all disassembled parts in the
4
figure 2
and/or cleaning