Waeco CoolPower MPS 35 Instrucciones De Montaje página 14

_MPS-35.book Seite 14 Donnerstag, 28. Mai 2009 5:13 17
General safety instructions
Maintenance and repair work may only be carried out by quali-
fied personnel who are familiar with the risks involved and the
relevant regulations.
2.2 Safety when installing the device
Ensure that the device is standing firmly!
a
The device must be set up and fastened in such a way that it
cannot tip over or fall down.
Take the precautions necessary to ensure that children cannot
interfere with operation. Dangerous situations may occur which
cannot be recognised by children!
Do not expose the device to a heat source (such as direct sun-
light or heating). Avoid additional heating of the device in this
way.
For installation on boats
If electrical devices are incorrectly installed on boats, corrosion
a
damage might occur. Have the inverter installed by a specialist
(marine) electrician.
Electrical cables
If cables have to be fed through metal walls or other walls with
e
sharp edges, use ducts or tubes to prevent damage.
Do not lay cables which are loose or bent next to electrically
conductive material (metal).
Do not pull on the cables.
Do not lay the 110 – 240 V~ mains cable and the 12/24 V
DC cable in the same duct.
Fasten the cables securely.
Lay the cables so that they cannot be tripped over or damaged.
14
CoolPower MPS35