OTC 6075 Manual Del Usuario

Crankshaft Damper Remover / Installer Kit
Application: 1995 and newer 2.0L 4-cylinder Neon, Cirrus, Stratus, Breeze
3
2
1
Operating Instructions
Removal
1. Remove the crankshaft damper bolt.
2. Install the insert into the crankshaft damper bolt
hole, tapered end  rst. See Figure 1.
3. Attach the 3-jaw puller to the damper.
4. Tighten the forcing screw on the puller to push
against the insert.
5. Remove the crankshaft damper.
Installation
1. Place nut, bearing, and damper onto the installer
screw.
2. Turn screw into the crankshaft until the screw
bottoms in the crankshaft. Note: This step is
important to ensure correct thread engagement.
3. Use a wrench to hold the screw, and turn the nut
clockwise until the damper is fully drawn onto the
crankshaft.
4. Remove the screw, nut, and bearing assembly.
5. Install the damper bolt, and tighten the bolt to
speci cations.
© Bosch Automotive Service Solutions LLC
655 Eisenhower Drive
Owatonna, MN 55060 USA
Phone: (507) 455-7000
Tech. Serv.: (800) 533-6127
Fax: (800) 955-8329
Order Entry: (800) 533-6127
Fax: (800) 283-8665
International Sales: (507) 455-7290
Fax: (507) 455-7063
Chrysler
2.4L 4-cylinder Cirrus, Stratus, Breeze
2.5L V-6 Cirrus, Stratus, Breeze
3.5L V-6 New Yorker, LHS, Concorde, Intrepid, Vision
4
5
7
6
8
9
10
Parts List and
Operating Instructions for:
Parts List
Item Part
No. No. Qty.
1 22021 6
2 22025 6
3 39942 1
4 314664 1
5 440656 3
6 10384 6
7 314662 1
8 314665 1
9 217801 1
10 220026 1
Insert
3-Jaw Puller
Figure 1
CAUTION: Wear
eye protection that meets
ANSI Z87.1 and OSHA
standards.
Form No. 106266
6075
Description
Hex Hd. Screw
Strap
Cross Head
Forcing Screw
Jaw
Hex Jam Nut
Extension
Forcing Screw
Bearing
Hex Nut
Sheet No. 1 of 3
Rev. C September 26, 2014