STANNOL 750100/110 Manual Del Usuario página 9

4. The soldering wire is filled with flux (to help it flow). Bring it to the
extreme end of the soldering tip and then melt it off (3). This will enable
the escaping flux to cover the soldering point, dissolve any oxides
that may be present, and ensure that the solder binds well with the
work-piece.
5. Use the stand (4) provided for resting the soldering iron.
Don't put the soldering iron down on any inflammable surface.
6. Do not shock-cool the soldering iron in water but just allow it to
cool off in the air.
7. The soldering tip must not be replaced until the soldering iron has
cooled off and has been disconnected from the mains. Pull the plug
out and loosen the fastening screws. Carefully loosen the tip with
gentle turning movements. Insert the new soldering tip as far as it will
go because otherwise the heating element will burn out immediately.
Subject to technical modification and colour changes.
Following information is only for EU-member states
The use of the symbol indicates that this product may not
be treated as household waste. By ensuring this product is
disposed of correctly, you will help prevent potential negative
consequences for the environment and human health, which
could otherwise be caused by inappropriate waste handling of
this product. For more detailed information about recycling of
this product, please contact your local city offi ce, your house-
hold waste disposal service or the shop where you purchased
the product.
EU Declaration of conformity
STANNOL GmbH & Co. KG
hereby declares that this product conforms with Direc- tives
DIN EN 60335-1 (VDE 0700-1):2007-02;
EN60335-12002+A11+A1+A12+Corr.+A2:2006
DIN EN 60335-2-45 (VDE 0700 Teil 45):2003-06; EN 60335-2-45:2002
DIN EN 50366 (VDE 0700-366):2006-11; EN 50366:2003+A1:2006
.
Karl-Heinz Dörr
Managing Director