Novellini 13061 EVA Instrucciones Y Mantenimiento página 8

ENGLISH
ø63
ø200
SYSTEM PREPARATION
1 Prepare an inspection recess equipped with shut-off keys, of adequate
size to allow the necessary water connections. At or downstream of
the shut-off key, it is advisable to provide an inspectable inlet water
filter. If the shower column is equipped with timed taps, installation of
the filter is essential for recognition of the warranty.
2 Install, from the recess to the column installation point, a corrugated
sheath with a diameter of 6 cm, whose vertical edge is located at a
minimum distance of 15 cm from the finished floor surface.
ø250
416
Cod. 13061 EVA
3
Totem column set Ø 63x2273 mm in brushed Aisi 316L with built-in
mixer and diverter, complete with shower head in Aisi 316L Ø 250x2
mm, shower in Aisi 316L, round brushed, 1 jet and anti-twist hose 150
cm Aisi 316L.
3 Prepare two removable pipes (one for hot water and one for cold water)
for polypropylene/polyethylene or similar connection, equipped with
1/2" male threaded terminals.
4 Bleed the system upstream of the recess.
This operation is particularly important as any impurities, such as
masonry residues, could obstruct the pipes, taps, mixer cartridges, the
shower head, etc.
2
-8-
1
4