ZIGLINT Y8278FL Manual Del Usuario página 8

When sucking up liquids, always keep the device in the vertical
position, with the suction inlet facing downwards. Never place
the device in any other position and never allow liquids to come
into contact with the motor.
a) Remove the device from its recharge seat (8).
b) Use the liquid suction attachment as final attachment (6);
apply pressure to it to attach it.
c) Push the switch (3) forward to switch the appliance on.
d) Keep the device on with the suction inlet facing down at all
times.
e) Pull the switch (3) back to switch the appliance off.
Note: Empty the container immediately after use and wash the
filter. Rinse the container and the filter in cold water and let all
parts dry completely before reassembling them.
Recharging the device
• Insert the plug of transformer into the power outlet.
• Make sure the on/off switch (3) is in OFF position (turned off).
• Please recharge the device. When the device will be correctly
positioned then the LED will display a red light.
Note: when you are not using the device, keep it always placed in
its recharge seat (8).
• Place the device in its seat and let it recharge for at least 2
hours.
• If the device is used until the batteries are completely flat, it
should then be recharged with a complete recharging cycle of
14 consecutive hours.
• Don't let the device uncharged for a long time, because the
inner accumulators may be damaged.
How to empty the container and clean the filter
• Press the opening button (1) and unhook the dust container (5).
• Remove the dust filter from the inside of the container and
empty the dust container (5).
EN-5