Lumos Matrix Manual Del Usuario página 3

USER INSTRUCTIONS
WARNINGS:
FOR USE IN NON-MOTORIZED RECREATIONAL PEDAL
CYCLING ONLY. NO HELMET CAN PREVENT AGAINST
ALL INJURIES. SERIOUS INJURY OR DEATH MAY OCCUR
WHILE CYCLING EVEN WITH A HELMET. LUMOS MAKES
NO CLAIM THAT THIS HELMET WILL ELIMINATE ALL POS-
SIBILITIES OF INJURY.
LUMOS LIGHTS ARE DESIGNED TO BE A SUPPLEMENT
AND NOT A REPLACEMENT TO REGULAR BIKE MOUNT-
ED FRONT AND BACK LIGHTS. CERTAIN STATES, CITIES,
AND COUNTIES HAVE LAWS THAT REQUIRE CYCLISTS TO
HAVE BIKE MOUNTED FRONT AND BACK LIGHTS AT ALL
TIMES. PLEASE ENSURE THAT YOU ARE AWARE OF, AND
COMPLY WITH YOUR LOCAL LAWS.
LUMOS IS DESIGNED TO BE A SUPPLEMENT, AND NOT A
REPLACEMENT TO HAND SIGNALS. PLEASE CONTINUE
TO GIVE HAND SIGNALS WHILE CYCLING ON THE ROAD.
WHILE WE DESIGNED THE "HARD BRAKE" AND TURN
SIGNALS TO BE AS RECOGNIZABLE AND INTUITIVE AS
POSSIBLE, WE MAKE NO CLAIM THAT MOTORISTS OR
PEOPLE AROUND YOU WILL RECOGNIZE WHAT THEY
MEAN, OR THAT THEY WILL SEE IT. HAVING LIGHTS IS
GOOD PRACTICE, BUT IS NO GUARANTEE AGAINST PRE-
VENTING AN ACCIDENT OR COLLISION.
WHEN ACTIVATING THE TURN SIGNAL, GLANCE AT THE
REMOTE TO ENSURE THAT YOU ACTIVATED THE COR-
RECT TURN SIGNAL.
ACTIVATING THE WRONG TURN SIGNAL OR LEAVING
YOUR TURN
SIGNAL ON CAN BE VERY HAZARDOUS AND CAN PO-
TENTIALLY INCREASE THE RISK OF A COLLISION DUE TO
THE MISCOMMUNICATION. AFTER COMPLETING YOUR
TURN, ALSO BE SURE TO TURN THE TURN SIGNAL OFF.
THIS HELMET IS NOT DESIGNED FOR MOTOR VEHICLE
USE AND NOT FOR SPORTS OTHER THAN THOSE FOR
WHICH IT WAS CERTIFIED. EVERY TIME YOU USE THIS
HELMET CHECK THAT NOTHING IS BADLY TORN, WORN,
MISSING, OR OUT OF ADJUSTMENT. THIS HELMET
SHOULD NOT BE USED BY CHILDREN.
INSTALLATION INSTRUCTIONS
ATTACHING THE REMOTE MOUNT TO YOUR HANDLEBARS:
1) Attach the mount to your handlebar using 2 silicone rubber bands. Do so
by looping each band around the diagonally opposite corners of the mount.
2) Place the remote on the mount and twist clockwise to lock it in
place.
button while the helmet is turned on.
Note: Using the solid mode will decrease the battery life of your helmet from
a single charge.
USING THE HELMET
TURNING THE HELMET ON/OFF + SELECTING THE FLASHING/SOILD
MODE:
To turn on, give the power button a short press.
To switch between the different modes, short press the power
button while the helmet is turned on.
Note: Using the solid mode will decrease the battery life of your helmet from
a single charge.
CHARGING THE HELMET AND REMOTE
Note that when the battery on the helmet is low, the power button will start
flashing red. At this point there is only approximately 30min of charge left in
the helmet. When the battery on the helmet is critically low and is about to
shut off, before it does so the helmet will beep several times to inform you
that it is about to shut off.