Printing Data With The Microlife Diagnostic Printer - Microlife PF 100 Manual De Instrucciones

• Memory Full
When the memory is full with 240 data,
the monitor gives a warning «beep»
when switching on and «MR 240» is
blinks. From
memorised but the oldest values are
automatically erased!
• Memory Clear
Note: the memory is automatically cleared after data transfer to
computer.
Clearing all data from the memory manually should be done when you intend to
give the monitor to another person. To clear all data press the «<» and the «>»
buttons simultaneously for 5 seconds, and then release the buttons. «clr» starts
blinking in the display for about 3 seconds. If you really want to erase all data
from memory you need to press the ON/OFF button during these seconds.
Otherwise the monitor moves back to normal operation and the data remains.
• Clear the last measurement
You can erase the last memory reading by pressing both memory scroll buttons
simultaneously for 5 seconds. After releasing the buttons «clr» will flash on
the screen for 3 seconds. To erase the last reading you need to press both
buttons again while the screen is flashing.
9. Print Data with the Microlife Diagnostic Printer
The monitor can be connected with the
Microlife diagnostic printer (available as an
accessory) to print data from the memory.
1. Open the Data Compartment from the
underneath.
2. Connect one end of the printer cable into
jack next to the printer symbol and the other
end with the printer next to «Input». It does
not matter which end of the cable you insert
into which device.
now on, data is still
the
11