Functional Description - Makita XAG06 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and the
battery cartridge is removed before adjusting or
checking function on the tool.
Installing or removing battery cartridge
1
2
015306
CAUTION:
Always switch off the tool before installing or
removing of the battery cartridge.
Hold the tool and the battery cartridge firmly
when installing or removing battery cartridge.
Failure to hold the tool and the battery cartridge
firmly may cause them to slip off your hands and
result in damage to the tool and battery cartridge
and a personal injury.
To remove the battery cartridge, slide it from the tool
while sliding the button on the front of the cartridge.
To install the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Insert it all the way until it locks in place
with a little click. If you can see the red indicator on the
upper side of the button, it is not locked completely.
CAUTION:
Always install the battery cartridge fully until the
red indicator cannot be seen. If not, it may
accidentally fall out of the tool, causing injury to
you or someone around you.
Do not install the battery cartridge forcibly. If the
cartridge does not slide in easily, it is not being
inserted correctly.
Switch action
CAUTION:
Before installing the battery cartridge into the tool,
always check to see that the switch lever actuates
properly and returns to the "OFF" position when
released.
Do not pull the switch lever hard without pulling
the lock-off lever. This can cause switch breakage.
1. Button
2. Red indicator
3. Battery
cartridge
3
1
015307
To prevent the switch lever from being accidentally
pulled, a lock-off lever is provided. To start the tool, pull
the lock-off lever toward the operator and then pull the
switch lever. Release the switch lever to stop.
Accidental re-start preventive function
Even if installing the battery cartridge while pulling the
switch lever, the tool does not start.
To start the tool, first release the switch lever. Then pull
the lock-off lever and then pull the switch lever.
Indicating remaining battery capacity
1
015141
When you turn the tool on, the battery indicator shows
the remaining battery capacity.
The remaining battery capacity is shown as the
following table.
Battery indicator status
Blinking
On
Off
015096
7
1. Lock-off lever
2. Switch lever
2
1. Battery indicator
Remaining battery capacity
50% - 100%
20% - 50%
0% - 20%
Charge the battery

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Xag07

Tabla de contenido