Purging The Paint Hose; Hose Disposal; Important - WAGNER ROLL'N GO Manual Del Propietário

When you are finished with your project, follow these steps to return any remaining material left in the hose back into its
container. These steps should be followed no matter what type of material you used.
1. Remove suction tube from material container and place in
bucket of appropriate cleaning solution (warm, soapy
water for latex paints, mineral spirits for oil-based paints).
3. Press locking tab (a) and drop roller cover assembly into
a bucket of the appropriate cleaning solution.
(a)
Hose disposal (latex materials only)
The pump assembly and hoses that come with your unit have been designed to be disposable.
• If you used latex materials and want to throw away the hoses, follow the Cleaning the roller handle and roller arm
instructions (page 8). If you throw away the hoses, new hoses can be purchased at the retailer where you
purchased this roller.
• If you want to clean the hoses for future use, however, follow the Cleanup - latex materials or the Cleanup - oil based
materials steps on the following pages.
IF YOU USED OIL-BASED MATERIALS, DO NOT THROW AWAY THE HOSES UNTIL YOU HAVE COMPLETED ALL OF THE
STEPS IN THE CLEANUP FOR OIL-BASED MATERIALS SECTION (PAGE 7). YOU WILL NEED THE HOSES IN ORDER TO
CLEAN YOUR ROLLER HANDLE AND ROLLER ARM.

Purging the paint hose

IMPORTANT

2. Remove spatter shield.
4. Remove lid and hold roller arm over material container.
FULLY PRESS AND RELEASE the handle button to
pump material through the hose and into the material
container. Fully press handle button again when cleaning
solution starts to come out of the roller arm.
5
English