Tristar BL-4007 Manual De Instrucciones página 14

• Never leave the machine alone while it is switched on.
• Keep the machine out of the reach of children.
• Repairs must be carried out by a qualified mechanic.
• Before using the machine check that the mains voltage is the same as stated on
the type plate.
• Only connect the mincer to an earthed socket.
• Regularly check that there is no damage to the wire. Do not use the machine if it
or the wire is damaged. Have a damaged wire replaced by a qualified technician.
• When pulling the plug out of the socket hold the plug and do not pull on the wire.
• Make sure that the wire does not come in contact with hot surfaces or steam.
• Make sure that the wire does not hang over the edge of a table or working top or
on the floor.
• Always pull the plug out of the socket before you move the mincer and when it is
not in use.
• Do not use the machine in the direct vicinity of heat sources (such as a cooker or
hot oven).
WARNING
• Always pull the plug out of the socket before you clean or use the mincer.
• The cutter is very sharp. Be careful not to injure yourself with it.English
• Never immerse the motor unit or the wire in water or any other liquid. This
could cause an electric shock.
• Do not use any aggressive or scouring cleansers or sharp objects (such as
knives or hard brushes) when cleaning.
Do nut use the mincer continuously longer than 30 seconds; leave it to
cooldown for 2 minutes before re-operate during 30 seconds.
Use
• Do not use the mincer outside.
• Place the mincer on a flat, stable surface where it cannot fall into the sink.
• Do not use any cutters, beakers or lids from other types of mincers.
• Do not fill the mincer beaker until the cutter has been put in place otherwise the
cutter will not fit in easily and the mincer will not work properly.
• Only put soft ingredients in the mincer beaker (no sand, grit, nutshells or similar).
See the table of ingredients for examples of ingredients that can be used.
• Make sure that the mincer beaker, the lid and the motor unit are properly fitted
together before switching on the mincer. Wait until the cutter has completely
stopped and pull the plug out of the socket before opening the mincer.
• Make sure your hands are dry before switching on the mincer.
• The mincer switches off automatically when the on/off button is released.
• Empty the beaker after use and clean out any food remains.
• Never immerse the motor unit or the wire in water or any other liquid.
• Do not pick up the machine if it should fall in water. Pull the plug out of the socket,
switch the machine off and do not use it again.
• The mincer is only intended for household purposes and is not suitable for
professional use.
14