Refitting The Plinth; Table For Cutting Away The Plinth - Fagor LVF 77 IT Manual De Instalación

EN
2 / INSTALLING YOUR DISHWASHER

• REFITTING THE PLINTH

Refit the plinth, cutting it away if necessary
according to Dimension P (see table and Fig.
10.1)
P
Calculate dimension P (Table on last page):
- Take Dimension B from Fig. 6.1 and measure
the gap J between the floor and the bottom of
the dishwasher. Calculate B - J.
P
- Measure the plinth depth E (Fig. 10.1) bet-
E
ween the unit's plinth and front of the unit.
Take the value for P from the table provided by
Fig. 10.1
E and B – J (e.g. if E = 100 and B – J = 140,
then P = 23).
- Cut away the plinth across a width of 600mm
to the depth for the value for P.
If there will be a specific plinth for the dis-
hwasher, you must obtain a separate fixing
kit (32X3252) from the After-Sales
Department. In this case, the plinth height is
H = B - P (Fig. 10.2).
Fig. 10.2

• TABLE FOR CUTTING AWAY THE PLINTH

P =
Cut-away depth
B J
35