Removing The Unit; Din Rear Mount (Method B) - Jensen MP1314 Manual Del Propietário

MP1314

Removing the unit

1. Make sure the ignition is turned off, then disconnect the cable from the
vehicle battery's negative (-) terminal.
2. Remove the metal strap attached the back of the unit (if attached).
3. Press the release button to remove the front panel.
4. Lift the top of the outer trim ring then pull it out to remove it.
5. Insert both of the supplied keys into the slots at the middle left and right sides
of the unit, then pull the unit out of the dashboard.

DIN Rear Mount (Method B)

If your vehicle is a Nissan or Toyota, follow these mounting instructions.
1. Use the screw holes marked T (Toyota), N (Nissan) located on both sides of the
unit to fasten the unit to the factory radio mounting brackets supplied with
your vehicle.
Factory Radio
Mounting Bracket
Screw
Side View showing
Screw Holes marked
T, N
Screw
Dashboard or Console
7