Water Dispenser Maintenance - Sunbeam 0282 Manual Del Usuario

WATER DISPENSER MAINTENANCE

WATER TANK CLEANING INSTRUCTIONS
1) Do not flick the power switches quickly on and off. The resulting power surges may
damage your water dispenser.
2) Always turn your water dispenser off when there is no water left in the bottle
or when you are changing bottles. Turn it back on after the new bottle has
been placed and the air is purged from the dispensing buttons.
3) To clean the unit, first unplug the power cord. Wipe the outside of the water dispenser
with a soft cloth dampened with liquid dishwashing soap. Use toothpaste to remove spots
on the cabinet.
4) Twist the bottle receptacle of the No-Spill system counterclockwise and pull it up (Fig. A ) .
5) Take apart the No-Spill system by unscrewing the base (piercing pin) (Fig. B). Then proceed
to wash it with dishwa s h i n g liquid, rinse it and reassemble.
6) Clean the inside of the water dispenser periodically with a small amount of vinegar. This
removes mineral scaling caused by the water. Rinse it well. Use the drain on the back in
order to get the water out. Make sure to open up all the taps to ensure that all cleaning
liquid is drained from your water dispenser. Put all of the parts back, securely fasten the
drain plug (Fig. C). It is important to let the water dispenser dry for TWO HOURS before
plugging it back in. Cover the bottle receptacle to prevent it from contamination.
7) The harder the water you use, the more often you should clean the interior of the unit.
Recommended intervals are between one and three months depending on the mineral
content of the water and the frequency of bottle changes.
S E RV I C I N G
UNPLUG THE UNIT BEFORE SERVICING
• When cleaning the unit, the coils on the back of the unit and the outside surface of the unit can be washed with a soft damp cloth. Don't
use chemical solvents or abrasives as they can damage the unit and may change the color. Do not pour water directly onto the outside of the
unit, this could damage some electrical parts - instead use a soft damp cloth.
• Keep the water dispenser 6"/15cm from the wall so the radiator can work properly. Keep in a well-ventilated area, free from direct sunlight :
ideal location is a shady, cool area. Make sure the ventilation opening is clear of obstruction.
• Do not damage the black coil on the back of the unit.
• If the water dispenser is not in use for a long time, please disconnect the power cord and drain the water from the unit using the drain plug
located at the back. Once drained, replace the drain plug tightening firlmly onto the unit.
• Keep children away from the hot water tap.
CAUTION: The hot tank empties from the unit first, therefore when the drain plug is opened, hot water will
!
drain first. To avoid injury, let the water dispenser stand unplugged for 10 hours before
opening the drain plug.
To remove the cap (to drain water), turn it CLOCKWISE. When you screw the cap back
on, please ensure the rubber portion of the seal is INSIDE the cap to avoid any leakage
of water.
A
Tw i s t
B
C
!
- 6 -
No. 0282
L i f t
Piercing Pin
D ra i n