EN
•
Never use the jumper leads in explosion-prone
surroundings.
•
Thaw frozen batteries before starting.
•
Verify the on-board voltage matches the input
voltage specified on the device to prevent dam-
age to the device.
•
Immediately stop using the device if you notice
smoke or an unusual odour.
•
Never expose the device to direct sunlight.
•
Batteries can burst or explode when thrown
into fire or exposed to extreme heat. Do not
expose the device to extreme heat.
Risk of chemical burns!
•
Avoid any contact with caustic battery acid. Im-
mediately thoroughly flush skin and any objects
which have come into contact with acid. If eyes
have come into contact with battery acid, flush
eyes with running water at least 5 minutes.
Contact your physician.
•
Use safety goggles and acid-proof safety
gloves. Protect clothing, e.g. with an apron.
•
Always ensure adequate ventilation.
•
Do not inhale emerging gasses and vapours.
Risk of electric shock!
•
Do not allow the clamps involved to touch.
•
Never allow the contacts of the lead connected
to the battery's positive terminal to come into
contact with electrically conductive vehicle
parts.
•
Avoid pouring or dripping water or other liquids
over it. If water penetrates electrical devices,
the risk of electric shock increases.
•
Ensure that all plugs and cables are free of
moisture. Never connect the device to the
mains with wet or moist hands.
•
Do not use device if damaged. Damage to the
power cable, the device or the charging cable
increase the risk of electrical shock.
•
Only unplug the cable from the outlet by the
plug. The cable could be damaged.
•
Never use the cable to carry or pull the device.
•
Do not attempt to disassemble or repair the
device. Immediately have a defective device or
damaged power cable repaired or replaced by a
speciality shop.
•
Never operate the device if it has been dropped
or damaged in any other way. For inspection
and repair, take it to a qualified electrician.
12
f1.mts-gruppe.com
Risk of injury!
•
Do not modify, open or manipulate the device.
This will increase the risk of injury.
•
Check the device for damage before every use.
Do not use a defective device.
•
Do not look directly into the light source on
this device during operation. If necessary, wear
suitable safety glasses.
•
Never blind persons or animals.
•
When transporting the device in a vehicle, keep
it in the boot or on a suitable shelf so that it
cannot move in the event of sudden vehicle
movements.
Risk of damage!
•
Keep the device and the USB charging cable
away from open fire and hot surfaces.
•
Do not cover the device as it may be damaged
from extreme heating.
•
Regularly check the charge of the battery pack
when stored for extended periods.
Produc t Over-
view
1. Display
2. Activation button
3. Jumper leads connection
4. USB port
5. USB charging port
6. LED light
7. Jumper leads
8. USB charging cable 2 A
Use
Information about use
•
Do not cover the device during use and ensure
proper ventilation.
•
The device automatically shuts off after 30
seconds when not in use. The display will turn
off.