Fermax MDS-2H Manual De Instrucciones página 17

Decoder MDS-2H
Decoder MDS-2H
Relay Terminals:
C: Common
R: NA, NC configurable by means of SW2 switch.
LED Signalling (DL1). Decoder Status LED:
· Off: Indicates that the decoder has not been programmed yet.
· On: Indicates that the decoder is in programming mode.
· 1 blink every 3 seconds: Indicates that the decoder is programmed and in night mode (no guard units active).
· 2 blinks every 3 seconds: Indicates that the decoder is programmed and in day mode (a guard unit is active).
· Rapid blinking: The decoder is running a telephone programming cycle.
DL5..DL12 LEDs signalling. Error Indication LEDs:
· If DLx is off:: The associated output is programmed and operative or else has not yet been programmed.
· If DLx is on: The associated output is programmed but disabled (line error).
Pag 18