Wilfa MOIST C Manual De Instrucciones página 18

EN
Control panel does
not work.
White dust
appears around
the humidifier.
Mist is coming out
from the base.
Mist fog coming
out from around
nozzle.
The warm mist
function does not
produce warm
mist.
Display show error
code EF.
The following is not considered faulty operation:
• If your water is very hard (containing abnormally high levels of minerals) the
humidifier may produce white dust. This is not a malfunction. The solution
would be to clean the filter more often or use softer water.
• If you stand very close to the humidifier, you will hear the gurgling sound of
INSTRUCTION MANUAL · HUMIDIFIER
Hands are too wet when
operating control panel.
Humidifier has
malfunctioned.
Water being used has a
high mineral content.
Humidifier was not
properly cleaned after
last use.
Water tank is not
positioned correctly.
There are apertures
between the nozzle and
water tank.
The humidifier is in
warm-up phase.
The mist is too fine to
feel the warmth.
The room temperature
is too cold, and the
mist may cool down too
quickly.
Too much water in water
basin.
16
Keep hands dry while
operating the control panel.
Contact Customer Support.
Use distilled water with the
humidifier. If distilled water is
not available, use purified or
filtered water.
Clean humidifier.
Turn off and unplug the
humidifier, then align the water
tank cover with its respective
opening in the inner chamber.
Reposition the cover and
check if the nozzle is well
plugged in the cover.
Wait a few minutes till the end
of the phase.
Increase the speed level.
Increase the speed level and
heat the room up.
Remove water tank and empty
water from the base.
Check and clean particles in
water outlet of water tank that
led to leakage. If no leaks,
replace into base.