Programming The Monitor - Fermax DIGITAL 5 HILOS Manual De Instrucciones

KIT
VIDEOPORTERO DIGITAL 5 HILOS
VIDEOPORTERO DIGITAL 5 HILOS

PROGRAMMING THE MONITOR

Once the monitor is connected, follow these steps to programme it:
1. Set the J1 switch in the
PRG position. You will
hear a confirmation
tone.
The time between steps 1 and 2 must be less than 2 minutes. If this period is exceeded,
set the jumper in its original position and start the sequence again.
VERY IMPORTANT NOTES
The monitor will not work until it has been programmed.
Check the monitor is operating correctly by pressing the auto-on key, making
sure that communication with the outdoor panel is established and the door
release is working.
Adjust audio level on the amplifier if necessary.
J1
PRG
2. Press the house call
button. Confirmation
tone is heard again.
N
TIO
SO LU
RE NI TO R
HI GH
MO
FL AT
H I G H I G
H R H R
E S O E S O
C C C C
D C D C
L U T L U T
A M A M
I O N I O N
E R A E R A
P A N A N
& T & T
IL T IL
3. Return switch to original
setting and position the
Monitor.
N
TIO
LU
SO R
RE NI TO
HI GH MO
AT
FL
J1
PRG
N
TIO
SO LU
RE R
HI GH NI TO
MO
FL AT
Pag 39