Abnormal Operation; Safety Instructions - Nilox BASIC Manual Del Usuario

4.3 The player does not play any sound after it has been
switched on
- Verify that the jack of the earpieces is correctly
connected,then check that it hermetically sealed.
- The volume may be too loud. Increase it.
- Verify that there is no water inside the earpieces and,if
necessary,remove the water drops as shown in the figure.

4.4 Abnormal operation

- If no sound is played during the playing mode and the LED
flashes normally, reset the player.
- If the LED continue sto be off, remove the earpieces and reset
the player.
Note: the reset operation does not cause the deletion of the
files.
4.5 The player does not connect to the PC
- Verify that the player has been connected to the PC by means
of the correct cable.
- Connect the cable to the MP3 player,then to the USB port of
the PC.
If the sequence is reversed,the device could not operate.

5. Safety instructions

- A prolonged exposure to high volumes may damage hearing.
Reduce the volume and length of use.
- Do not use the player when driving a vehicle,because this may
prevent you from hearing other noises and cause injuries to
other people.
6