Mellerware Koffy! Manual Del Usuario página 10

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 11
ESPAÑOL
Anomalie
Water comes out of the
side of the filter holder
No coffee comes out
The coffee comes out
slowly or drop by drop
The coffee comes out
without cream
Coffee comes out
too fast
No steam comes out
of the steam wand
Cause
- The filter holder is not
positioned correctly.
- The edge of the
saucepan is covered in
coffee.
- The brewing group
is dirty.
- There's no water.
- The water tank is not
correctly positioned.
- The holes in the pot are
clogged, the coffee is
ground too finely or has
been pressed too hard.
The coffee is too ground or
too pressed.
- The coffee that has been
used, is old or has dried.
- The coffee has not been
pressed enough.
- The coffee grounds are
too coarse.
- The coffee is very coarsely
ground.
- Not enough coffee
has been put into the
saucepan.
- The coffee has not been
pressed enough.
The tube is clogged.
Solution
- See section "coffee
filling".
- Clean the pan around
the edge and clean the
coffee brewing group.
- Clean with a damp
cloth.
- Fill the water tank.
- Check that the tank is
correctly positioned by
pressing on its upper part.
- Empty the ladle and
clean with water. Clean
the brewing group with
a damp cloth. Refill the
ladle again and press the
coffee lightly.
Make sure that the grind
size is correct and that
it has not been over-
pressed.
- Use fresh coffee and
once opened, store in an
airtight container.
- Firmly press the coffee.
- Grind the coffee finer.
- Grind the coffee finer.
- Make sure you have put
the correct amount of
coffee in the saucepan.
- Press the coffee more.
Clean the steamer pipe
with a damp cloth to
remove any traces of
milk that have dried and
open the holes with the
help of a needle. Press
the corresponding switch
and extract steam until it
comes out strongly and
continuously.
EN
ES

Publicidad

Tabla de contenido
loading

Tabla de contenido