Removing Icsa From Stroller; Removing Restraint Belt From Stroller - BOB CS1401 Manual De Instrucciones

REMOVING ICSA FROM
STROLLER
Remove Infant Car Seat
Adapter and Restraint Belt
when not in use.
Do not place children directly
in the stroller seat with the
Infant Car Seat Adapter
installed. Remove Infant Car
Seat Adapter from stroller
prior to placing a child
directly into the stroller seat.
Failure to follow these
warnings may result in
serious injury or death.
NOTE: For illustrative purposes,
Chicco compatible ICSA shown.
Other ICSA singles remove in same
manner.
Prepare Stroller
Set parking brake, rotate canopy
towards handlebar (see stroller
owner's manual if necessary).
1. While holding down Red Release
Buttons on both Accessory Adapters
at sides of stroller, pull ICSA forward
and out of Receiver Sockets, keeping
alignment even, left to right, as you pull.
2. Slide Covers UP
Push to slide each Cover (at front of
stroller Accessory Adapters) up on
each side of stroller, covering each
Receiver Socket.
REMOVING RESTRAINT BELT
FROM STROLLER
Restraint Belt is intended
for use with combination of
BOB Infant Car Seat Adapter
and compatible Infant Car
Seats only. The Restraint Belt
must be removed prior to
using stroller without Infant
Car Seat. Failure to remove
Restraint Belt when not in
use may result in accident,
injury or death.
15
P636900A