Machine-Specific Safety Warnings - Felisatti RH26/36CVR Instrucciones De Servicio

MACHINE-SPECIFIC SAFETY WARNINGS

• See "Safety Instructions" manual, supplied with this in-
struction manual.
• Warning! When drilling in amianthus/asbestos and/or
silica stone, the dust produced is extremely harmful to your
health. Wear protection against inhalation of this dust, in
compliance with current regulations on acci-dent prevention.
Follow the insurance company's safety instructions regarding
the responsibility of em-ployees.
• For your personal safety, always connect the machine to
a mains supply protected by a differential and thermal cutout
switch, in accordance with regulations on low-voltage wiring
sitemaps.
• Do not perforate the machine casing, as this would de-
stroy the protective insulation (use adhesive labels).
• Always unplug the machine before doing any work on
it.
• Warning! Before each use, inspect the plug and lead.
Should they need replacing, have this done by an official
service centre. Only plug the machine in when it is switched
off.
• Always keep the lead out of the machine's working
area.
• Only plug the machine in when it is switched off.
• Do not allow the machine to get wet, nor should it be
used in wet environments.
• When using the machine, always wear safety goggles,
gloves and non-slip footwear, and it is advisable to wear ear
protection.
• Do not touch the bit during or immediately after work-
ing, as it becomes very hot and can cause serious burns.
• Hold the machine firmly by the handle and the auxiliary
handle, otherwise the recoil produced could cause the ma-
chine to work imprecisely or even dangerously.
• Always use the auxiliary handle.
• Never attempt to clean off dust or shavings resulting
from drilling when the machine is operating.
• Do not use diamond core bits.
• When drilling walls, ceilings or floors, take care to avoid
electric wires and gas or water pipes.
3