Installing Battery And Setting Battery Type（Wet Or Gel/Agm - Viper AS430B Manual Del Usuario

b) Without batteries
1. Purchase similar battery (refer to the section on technical parameters). Information on the
selection of battery may be obtained from qualified battery agents.
2. Set the machine and the on-board charger (if equipped) according to the type of batteries (WET
or GEL/AGM). Also read the following paragraph for the way to install the battery.
INSTALLING BATTERY AND SETTING BATTERY TYPE（WET OR GEL/AGM）
According to the battery type(WET or GEL/AGM) set the electric circuit board on the on-board charger.
The procedures are as follows:
1. Make sure the connector of the battery is disconnected. If the
machine is based on "AGM" battery at time of ex-factory, go
directly to Step 8; otherwise, complete Steps 2, 3, and 4.
2. Take off draining hose (15)
3. If equipped with on-board charger, please take off the charge
wire from the reel.
4. Take off the control cover (5), and the screws of the battery
cover (10). Remove the screws on the PCB stand. The DIP
switch (B) for setting the battery model can be seen when
flipping over the PCB board. (See Figure 5)
5. Adjust the micro DIP switch (B) to the position of "WET",
6. Complete Steps 3, 4 and 5 in reverse order.
Installing batteries
7. Disconnect the battery connector（9）.
8. Open the recovery tanks cover (25) and check if the recovery tank is empty or not; if not, empty it
through draining hose (15).
9. Unscrew the squeegee fixed knob (16), take off the connector connecting the vacuum tube for
waste (11) to the squeegee, and then take off the squeegee.
10. Unscrew the screws of the battery cover (10) and remove the cover.
11. 11. Unscrew the connector of the squeegee drawing cord (12) connecting to the squeegee
bracket (19), and hang the squeegee drawing cord upwards.
12. Hang draining hose (15) and the vacuum tube for waste (11) upwards.
13. According to the size of the battery, push the fixation board in the battery box all the way inwards.
NOTE
The dimension of the battery must not exceed: H x W x H: 330mm x 170mm x 260mm.
According to the varying dimensions of batteries, the requirements for the selection of fixed
batteries are as follows:
1. For battery with length below 270mm, use 2 pieces of the fixation board (B, Figure 6)
and place them side by side inside the water tank battery;
2. For battery with length between 310mm-270mm, use 1 piece of the fixation board (B,
Figure 6) and place it in the water tank battery;
3. For battery with length between 330mm -310mm, there is no need for the fixation board
to fix the position.
USER MANUAL
Figure 6
7
ENGLISH
Figure 5