AMG CANADIAN 6 Manual Del Usuario página 49

We highly recommend to turn to our Authorized Service Centre for the
installation and the first ignition of the device as it not only carries out
the installation perfectly but also verifies the regular operation of it.
During the first lighting the environment should be well ventilated since during
the first hours of operation unpleasant odours could develop due to the physical
stabilizing of the paint and from the grease in the tube bundle.
Stove switching off
To switch off the stove, press the key
the stove has been switched off, the fan continues working for a set time in order to grant a fast smokes
exhaust from the combustion chamber.
If you have a model with remote control, you just need to switch the remote control off keeping the key
pressed for 2 seconds and confirming the selection pressing the key SEND.
If you try to switch on the stove during this phase, the display will show " " att e
for cooling) in order to inform you a switching off phase is running. Wait until the cooling phase is
completely off and the display shows " " O FF
REMARKS:
• Do not continuously turn the stove on and off as this could provoke sparks that could shorten the life
of the electrical components;
• Do not touch the stove with wet hands: the stove has electrical components that could produce sparks
if handled incorrectly. Only authorized technicians can resolve possible problems;
• Do not remove any screws from the fire chamber without first lubricating them well;
• Never open the glass door of the pellet stove while the stove is in operation;
• Be sure that the brazier basket is positioned correctly;
• The flue system must be suitable for inspecion. If it cannot be removed, it must have some holes for
inspection and cleaning;
In order to achieve the test report results, please load the performance parameters retained
by the manufacturer and the qualified tecnichian. They will use these parameters once
verified that, during the installation, it is possibile to reproduce the laboratory conditions.
on the control board until you read " " of f
O FF" " before staring a new light up.
of f" " on the display. After
att e" " (that means wait
9