Velleman DVR4H3 Guía Rápida página 5

PLAY Press to play the recorded video.
SLOW In playback mode, press to play the recorded file slowly.
ZOOM In live or playback mode, press to enlarge the image of the selected channel.
SEQ Press to show all screens sequentially in full screen mode. Press again to quit.
4CH: Press to show the 4 channel display mode.
1 ~4 Press a button to select the corresponding channel.
SEARCH Enter time search mode. Set time range and press START to see all recordings within
the time range.
= SLOW + ZOOM
AUDIO
Press SLOW and ZOOM simultaneous to select live or play4back sounds.
= SLOW +
P.T.Z.
Press SLOW and
Connect a USB flash drive for video backup to one USB port; connect a USB mouse
USB port
to the other.
(2x)
+(.: do not connect two USB flash drives or USB mice at the same time.
0.)0 3)&.*
LAN port Connect the DVR to a local network by plugging a network cable into this port.
VGA connector for video monitor*
AUDIO IN 4 audio input channels to connect four external audio sources e.g. from cameras
with audio.
AUDIO OUT 1 audio output to connect to an audio device, e.g. a speaker (mono).
VIDEO IN 4 video input channels to connect 4 external video sources e.g. cameras.
MONITOR 1 video output channel to connect the DVR to the main monitor.
EXTERNAL I/O use a 9 pin DSUB connector to connect external signals e.g. alarm, PTZ, ...
power switch
19V DC Power supply input.
)0-9)0. '.("3
&'()**#&, (2. )0-
Refer to the illustrations on page
• Obtain a suitable HDD (not included), type SATA (Serial Advanced Technology Attachment). The
HDD must be formatted.
)%. '"0. to unplug the device from the mains before servicing and -+ &+( touch any electronic
•
circuitry to avoid electrostatic discharge.
• Unscrew the 6 screws (1 on either side and 4 on the back) that hold the cover in place.
• Lift the cover (back first).
• Screw the mounting brackets on the HDD (screws included).
+(.: the PCB must be facing upwards when mounting the HDD into the DVR.
• Connect the SATA data cable and power supply to the HDD.
• Screw the HDD on the bottom of the DVR housing PCB facing upwards using the included screws.
• Close the cover (front first) and secure it with the 6 screws.
+&&.$(#&, ) 5#-.+ 4+&#(+0
• Obtain a suitable monitor (not included) and connect it to the BNC or VGA video output port on the
back of the DVR.
+&&.$(#&, (2. 3+9.0 '"33*8
• Plug the DC output connector of the included power adaptor into the 19VDC power input at the
back of the DVR.
< : only use the included adaptor.
• Plug the included power cable into the adaptor input connector and plug the other end into the
mains. + &+( switch the DVR on yet.
+&&.$(#&, ) $)4.0)
• Obtain up to four suitable cameras (not included). Each camera needs its own power supply.
18/01/2012
simultaneous to enter or exit PTZ control mode.
#'% 0#5. ? @
of this manual.
5
Rev. 01
©Velleman nv