Useful Suggestions - TRAPP DM 50 Manual De Instrucciones

www.trapp.com.br
Throghout the use of the corn thresher situations and/or problems may occur, for which we present some
suggestions:
Trouble Probable Cause
Equipment Excessive feeding. Due to that
jammed the motor can not maintain
necessary rotation, and the material
accumulates inside the equipment.
Use under this condition may cause
motor to overload.
Low production 1. Insufficient feeding of
equipment.
2. Motor rotation lower than
specified.
3. Humid product.
Trouble starting 1. Excessive intake of product in
motor equipment.
2. Electrical shortage.
TRAPP Symbols for Corn Threshers
Attention!
Warning.
Read operator's manual.
Use gloves for protection.

Useful Suggestions

Solution
Turn off equipment and wait for motor to come to
a full stop. Remove excess material, turn on the
equipment, wait for motor to reach maximum rotation
and restart work. Control feeding according to motor's
capacity.
1. Continuously feed the equipment. Remember,
however that overfeeding causes the equipment
to jam.
2. Verify if purchased motor to be installed on
equipment (equipment sold without motor)
is compatible with the specifications in the
equipment sticker.
3. Use dry corn only.
1. Once work is finished, always leave equipment
working for a few extra minutes to allow total
output of material.
2. Check conditions of electrical power source
(electrician).
Wear protection goggles and ear
protection.
Attention.
Keep hands and feet away.
Ground conection.
33