Fermax KIT MEMOVISION 100C DIGITAL Manual De Instrucciones página 14

Ocultar thumbs Ver también para KIT MEMOVISION 100C DIGITAL:
Tabla de contenido

Publicidad

Kit MEMOVISION
Kit MEMOVISION
TESTE DO TECLADO
Este kit vem pré-programado com 3 códigos predefinidos.
Os códigos pré-gravados são exclusivos de cada equipamento, portanto só Você os
sabe.
Também pode utilizar estes códigos para verificar o funcionamento do equipamento.
Para verificar o funcionamento, carregue no código correspondente e verifique se se activam
os dispositivos mencionados.
CÓDIGO
CODE 1 (*)
CODE 2 (*)
CODE 3 (*)
(*) Estes códigos estão indicados num autocolante na parte de trás do módulo do teclado.
CABLEADO INTERNO DE LA PLACA / INTERNAL CABLING OF THE PANEL / CÂBLAGE
INTERNE DE LA PLATINE / INTERNE VERKABELUNG DER TÜRSTATION / CABLAGEM
INTERNA DA PLACA
La placa de calle sale de fábrica precableada. El sistema no puede funcionar si
E
se eliminan o alteran estas conexiones. Por lo tanto, cuando Ud. abroche algún
cable en los terminales precableados debe conservar el cableado ya existente.
EN
The outdoor panel is supplied internally wired, as shown below. The system can
not work if these internal wires are removed or altered. Therefore, if you connect
any wire to a terminal already wired (from factory) be sure that none of these are
removed.
F
La platine de rue sort de l'usine munie d'une préinstallation de câbles. Le système
ne pourra pas fonctionner si ces connexions sont éliminées ou détériorées.
Ainsi, lorsque vous engagerez un câble dans les terminaux précablés, il vous
faudra conserver le câblage préexistant.
D
Die Verkabelung der Türstation wird werkseitig vorgenommen. Das System kann
nicht funktionieren, wenn diese Schaltungen entfernt oder verändert werden.
Daher müssen Sie die bestehende Verkabelung beibehalten, wenn Sie ein Kabel
an den vorverkabelten Polschuhen anschließen.
P
A placa de rua é fornecida de fábrica com a pré-cablagem. O sistema não pode
funcionar se se eliminarem ou alterarem estas ligações. Portanto, quando ligar
algum cabo aos terminais pré-cablados deve conservar a cablagem já existen-
te.
Pag 14
ABRIR A PORTA
ACTIVAR DISPOSITIVO AUXILIAR (se existir)
ABRIR A PORTA E ACTIVAR DISPOSITIVO AUXILIAR
ACÇÃO

Publicidad

Tabla de contenido
loading

Tabla de contenido