USING THE POOL BLASTER
LEAF DEMON
For Bottom Cleaning
Press the ON/OFF button on the battery box to start the Leaf
Demon. Using the pool pole, lift the Leaf Demon into the pool
and guide it to the pool bottom in the "Wheels Down" position.
For Surface Cleaning
Push the pole adapter down
until the adapter locks in place.
Turn the cleaner "ON."
The Leaf Demon may now
be used in the "Wheels Up"
position to skim leaves and
other floating debris from the
pool's surface.
Adjusting the Clearance Height
The Leaf Demon is packaged
with its clearance height in the
"LOW" position.
The height of the Leaf Demon
can be raised up to 1/4 inch if
needed by doing the following:
1. Use a small screwdriver or
pair of needle-nose pliers to
remove the "E"-clip from the
top of the wheel pivot shaft.
2. Remove the wheel pivot
shaft assembly. Don't lose the
"E" - clip and spacer.
(see Photo).
3. Place the spacer on the
pivot shaft and guide the shaft
back into the body
from beneath.
4. Replace the "E"-clip on the
top of the shaft.
Repeat these procedures on
the remaining 2 wheel pivot
assemblies.
Maintenance
ALWAYS clean out the debris bag following each use and
carefully remove any debris that might be stuck in the
propeller area of the cleaner.
Remove the batteries from the battery box prior to long-term
storage (ie. at the end of the pool season).
IMPORTANT SAFEGUARDS
1. Extreme care must be taken to avoid fingers,
toes, hair or any other body part from coming in
contact with the Impeller while the unit
is operating.
2. Operation of this unit by children and/or
persons of diminished physical or mental
capacity is not recommended unless they are
closely supervised by an authorized adult.
3. Always check the battery box cap to make
sure that it is completely closed before each
use. If water enters the battery box, it can
damage the unit but is not considered a
health hazard.
Pole Adapter Assembly
P11A061LD
Battery Chamber Assembly
P11A015LD
Filter Bag
P11AX022AP
Filter Ring
LVAC056
Leaf Demon Body
11A0050
Wheel Assembly
P11A050LD
5