Procedures During Sample Runs; Accessories; Power Supply / Switching Off - IKA KMO 3 basic Manual Del Usuario

/// Procedures during sample runs

Warning! ( )
Wear your personal protective equipment in accordance with the hazard
category of the media to be processed There may be a risk from:
› splashing and evaporation of liquids
› ejection of parts
› release of toxic or combustible gases
Reduce speed if:
› medium splashes out of vessel because the speed is too high
› device is not running smoothly
› container moves on the working plate
› an error occurs

/// Accessories

› Safe operation is only guaranteed with the accessories
described in the "Accessories" chapter
› Always disconnect the power before attaching accessories
› Observe the operating instructions of the accessories
› Accessories must be securely attached to the device so that
they cannot come off by themselves The centre of gravity of
the assembly must lie within the surface on which it is set up
30 Safety instructions

/// Power supply / Switching off

Place the power supply outside the working area of the device
› The voltage stated on the ratings plate must correspond to
the mains voltage
› The outlet for the power supply must be easily accessible
› The device can only be disconnected from main power by
unplugging the power supply from the outlet or removing the
connector plug at the unit
Warning! ( )
› The device will automatically restart in mode b following
any interruption to the power supply
Safety instructions 31