Basic Operations; Turning On The Cd Receiver; Selecting The Input Source; Adjusting The Volume - Onkyo CR-255 Manual De Instrucciones

Basic Operations

This section describes the procedure for using the
remote controller, unless otherwise specified.

Turning On the CD receiver

Press the On/Standby [8] button.
The CD receiver comes on, and the display lights up.
Press the On/Standby [8] button again to set the CD
receiver to Standby.
You can also use the [8 ON/STANDBY] button on the
CD receiver.
During the use of your iPod/iPhone connected to the
iPod dock and/or the CD receiver with a USB cable, your
iPod/iPhone will be charged even with the CD receiver
on standby and "Charging" appears on the display of the
CD receiver.
Tip:
• For details on power management settings, see "Set-
ting Auto Standby (ASb)" (see page 24).

Selecting the Input Source

You can select CD, iPod/USB, FM, AM, or LINE, which
can be an external component.
To select the input source, use the remote controller's
Input Selector buttons. On the CD receiver, press the
[INPUT] button repeatedly.
The input sources are selected in the following order.
CD iPod/USB

Adjusting the Volume

To adjust the volume, use the VOLUME [–]/[+]
buttons.
You can also use the CD receiver's VOLUME [–]/[+]
buttons.

Muting the CD receiver

You can temporarily mute the output of the CD receiver.
Press the [MUTING] button.
The CD receiver is muted.
"Muting" appears on the display for a few seconds. The
MUTING indicator flashes continuously while the CD
receiver is muted.
Note:
• To unmute, press the [MUTING] button again or
adjust the volume.
• Muting is automatically cancelled when the CD
receiver is set to standby.
16
En-
FM AM LINE

Using Headphones

You can connect a pair of stereo headphones (ø3.5 mm,
1/8-inch phone plug) to the CD receiver's headphones
[=] jack for private listening.
Note:
• Always turn down the volume before connecting your
headphones.
• While the headphones plug is inserted in the
headphones [=] jack, the speakers are turned off.

Adjusting the Bass and Treble

Press the [BASS] or [TREBLE] button, and then
use the arrow [q]/[w] buttons to adjust the bass
or treble, respectively.
The default setting is "0". You can adjust the bass and
treble from –5 to +5.
While adjusting the bass or treble, you can press the
[CLEAR] button to return the setting to "0".
Note:
• If you press no buttons for about 5 seconds, the
previous display will appear automatically.

Using Super Bass

To turn on Super Bass, press the [S.BASS]
button.
The setting will alternate between S.Bass Off, S.Bass 1,
and S.Bass 2 each time you press the button.
To turn off Super Bass, press the [S.BASS] button
repeatedly until "S.Bass Off" appears.
The default setting is "Off".
Note:
• If you press no buttons for about 5 seconds, the
previous display will appear automatically.

Changing the Display Brightness

You can adjust the brightness of the display.
Press the [DIMMER] button repeatedly to select:
dim, or normal brightness.