Publicidad
A A
A A
• Before storing the vacuum cleaner, rewind the power supply
cable by pushing the button (2) as shown in fig. 4.
Before any kind of maintenance, make sure that the supply
cable is not connected to the mains.
ATTENTION! Push the button (5) only if you want to replace the
dust bag, as indicated in the "replacing the dust bag"
paragraph.
REPLACING THE DUST BAG
The performance of the appliance depends on how full the dust
bag is. When the suction noticeably decreases, it is necessary
to replace the dust bag.
Push the button (4) and at the same time lift the cover (6) as
shown in fig. 5.
Position the appliance over a dust bin, then push the button (5),
the dust bag is released from the holder and will fall into the
dust bin (fig. 6).
INSERTING A NEW DUST BAG
Insert the lower edge of the dust bag cardboard support (7)
into the guide and push, inserting the upper edge of the
cardboard support into the two upper guides.
Check that the hole of the bag corresponds to the one of the
mouth (fig. 7).
Put the cover back by first making the two hooks go into their
grooves, then push downwards until you hear the click (fig. 7
bis)
REPLACING THE AIR INLET FILTER (13)
Lift the cover as indicated in the "Replacing the dust bag"
paragraph.
Take out the air inlet filter and replace it with a new one (10).
If the air inlet filter is damaged, replace it.
Note: it is recommended to replace the filter every five times
you replace the dust bag.
REPLACING THE AIR OUTLET FILTER (10)
Push the lever placed on the air outlet grill (9) and lift it (fig. 9).
Remove the filter and replace it with a new one (fig. 10).
Put the air outlet grill back in its position.
If the filter is damaged, replace it.
Note: it is recommended to replace the filter every five times
you replace the dust bag.
U U
S S
E E
O O
F F
U U
S S
E E
O O
F F
The accessories storage allows you to fix the accessories on
the appliance body or on the handle.
Installation on the handle: insert one of the rings of the
accessories holder on the handle. Repeat the same operation
for the accessories that you want to keep at hand.
Installation on the appliance body: make the groove of the
accessories holder run into the guide on the back of the
appliance, as shown in fig. 11.
U U
S S
E E
O O
U U
S S
E E
O O
Insert the brush. If you move the selector on the brush (B1) by
pressing with your foot, you can change the suction surface
without bending down. The position with the bristles outside is
recommended for all floors. The position without bristles is
recommended for carpets and rugs.
U U
T T
O O
M M
A A
T T
U U
T T
O O
M M
A A
T T
G G
E E
N N
E E
R R
A A
G G
E E
N N
E E
R R
A A
T T
H H
E E
A A
C C
C C
T T
H H
E E
A A
C C
C C
F F
T T
H H
E E
U U
F F
T T
H H
E E
U U
I I
C C
C C
A A
B B
L L
I I
C C
C C
A A
B B
L L
L L
M M
A A
I I
N N
T T
L L
M M
A A
I I
N N
T T
E E
S S
S S
O O
R R
I I
E E
S S
S S
O O
R R
N N
I I
V V
E E
R R
S S
N N
I I
V V
E E
R R
S S
E E
- -
W W
I I
N N
D D
E E
E E
- -
W W
I I
N N
D D
E E
E E
N N
A A
N N
C C
E E
E E
N N
A A
N N
C C
E E
E E
S S
S S
T T
O O
R R
I I
E E
S S
S S
T T
O O
A A
L L
B B
R R
U U
S S
A A
L L
B B
R R
U U
S S
R R
R R
A A
G G
E E
( (
I I
) )
R R
A A
G G
E E
( (
I I
) )
H H
( (
B B
) )
H H
( (
B B
) )
Publicidad
