Telwin DRIVE 9000 Manual De Instrucciones página 3

Ocultar thumbs Ver también para DRIVE 9000:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 14
INSTRUCTION MANUAL
WARNING: READ THE INSTRUCTION
MANUAL CAREFULLY BEFORE USING
THE STARTER!
1.
GENERAL
INSTRUCTIONS FOR THIS STARTER
In order to reduce the risk of personal
injury and damage to equipment, it is
highly recommended to comply with
all essential safety measures and
precautions when using the starter.
- Inexperienced
personnel
should
instructed before using the appliance.
- Children must be supervised to
prevent them from playing with the
appliance.
-
Protect the eyes. Always wear
protective goggles when using
acid lead accumulators.
-
Avoid contact with battery
acid. If an operator should be
sprayed or come into contact
with the acid, rinse the relative parts
immediately under clean running water.
Continue to rinse the area until the
physician arrives.
-
It is important to connect the
cables with the poles in the
right direction:
First connect the red clamp to the
positive terminal on the vehicle battery (+
symbol).
Connect the black clamp to the vehicle
chassis or the negative clamp on the
battery, at a distance from the fuel pipe.
- Use the starter in well ventilated areas.
Do not attempt to use the starter when
there is gas or inflammable liquids in
the vicinity.
- Do not allow the black and red clamps
to come into contact.
- FOR 12 VOLT SYSTEMS ONLY! This
device is destined for use on vehicles
running on 12 Volt electrical systems
only.
- USE IN EMERGENCY SITUATIONS
ONLY: do not use the starter instead of
the vehicle battery. Use it during start-up
operations only.
(EN)
SAFETY
and
untrained
be
properly
- Do not work alone. If there is an accident,
the assistant can be of aid to the operator.
-
conductors or bus bars. Avoid all body
contact with surfaces of tubes, radiators,
and metal power substations whilst
reading the vehicle battery voltage.
- Keep the work area clean at all times.
Untidy cumbersome areas can lead to
USER
injuries.
- Protect the starter appropriately from all
possible damage. It must only be used as
indicated in this Instruction Manual.
- Ensure compliance with the indications
in the work area. Do not use in humid
or wet facilities. Never leave it out in the
rain. Always work in well lit areas.
-
areas or handle any machines,
instruments or extensions.
-
can get caught up in moving parts.
During all operations, the use of
electrically
clothing and non-slip boots must be
worn at all times. Persons with long
hair must tie it back and wear a hair
net.
- Only experts are allowed to do repair
work on the starter as it involves
significant risk levels for inexperienced
workers.
- Replacing parts and accessories. When
performing
replace with identical and original spare
parts only. Use of non-original spare
parts invalidates all warranties.
- Make sure that the device is always
positioned in a stable and well supported
manner.
Never climb over cables or electrical
structures.
- Careful attention must be paid during
maintaining work on the starter. Check
the condition of cables on a regular basis
and if any damage is detected, have the
same repaired by an authorised and
qualified technician.
- Check there are no damaged parts.
Before using this starter, carefully
check that all seemingly damaged parts
- 3 -
Avoid electrical shocks. Be
very cautious when applying
the clamps to non-insulated
Keep
out
of
children: they must never
be allowed to access work
Always
wear
clothing. Never wear baggy
clothing or jewellery that
insulated
maintenance
reach
of
suitable
protection
operations,

Publicidad

Tabla de contenido
loading

Tabla de contenido