Publicidad
Idiomas disponibles
Idiomas disponibles
MOUNTING TO THE TABLE
•
Hook the Holding Bars over the front of the Mitre Saw Stand's main frame tubular crossbar.
•
Squeeze the Locking Lever of the Holding Bar down to engage them onto the Mitre Saw Stand
crossbars.
•
Lock the brackets into place by gently depressing the levers on the Holding Bar.
•
Place the Mitre Saw onto the Holding Bars, taking care to adjust and align the holes at the feet of the
Mitre Saw to the slots in the Holding Bars.
•
Place the screw through the hole from the bottom up of the Holding Bars and through feet of the
Mitre Saw (as shown).
•
Secure in place with the Spring Washer.
NOTE It is recommended during this process that at least one person is holding the Mitre Saw whilst it is being
secured to the Mitre Saw Stand.
EN
Publicidad
