Publicidad
WARNING
INSTALL, OPERATE OR SERVICE THIS WINCH. FAILURE TO COMPLY WITH
INSTRUCTIONS COULD RESULT IN SERIOUS OR FATAL INJURY. RETAIN THESE
INSTRUCTIONS FOR FUTURE REFERENCE.
• This winch is built for multi-purpose hauling and lifting operations. It is not
to be used as a hoist for lifting, supporting or transporting people, or for
loads over areas where people could be present.
• Respect this winch. High forces are created when using a winch, creating
potential safety hazards. It should be operated and maintained in
accordance with instructions. Never allow children or anyone who is not
familiar with the operation of the winch to use it. A winch accident could
result in personal injury.
• Check winch for proper operation on each use. Do not use if damaged.
Seek immediate repairs.
• Never exceed rated capacity. Excess load may cause premature failure
and could result in serious personal injury. This winch is rated with one
layer of cable on the hub. Using more layers of cable increases the load
on the winch. If the winch handle cannot be cranked easily with one hand,
or if using an electric drill, the drill labors significantly, the winch is
probably overloaded.
• If using an electric drill, do not connect the drill chuck directly to the winch
shaft. Attach drill with a shepherd's hook to the loop drive or with a 5/8"
socket on the hex shaft. To minimize heat build up and possible winch
damage, do not exceed 600 rpm.
• Never apply load on winch with cable fully extended. Keep at least three
full turns of cable on the reel.
• Secure load properly. When winching operation is complete, do not
depend on winch to support load.
WINCH MOUNTING AND CABLE ATTACHMENT –
strength and safety, this winch should be mounted with three 3/8" bolts
(M10), washers and lock washers. (See parts drawing). Install handle (or
loop drive ring) on drive shaft and secure in place with lock nut.
Attach cable or rope by method shown in sketch.
OPERATING INSTRUCTIONS –
when drive shaft is turned in a clockwise direction. Load will remain locked in
position when cranking stops. To lower load (reel out), turn the drive shaft
counterclockwise.
WINCH MAINTENANCE –
factory; but, for continued smooth performance and increased life, occasional
greasing of gears and reel shaft and an occasional drop of oil on drive shaft
bearings are recommended. If winch is operated with a drill, frequent
greasing may be necessary. Check often enough to establish an appropriate
schedule. The winch finish can be protected and will provide longer service
if it is periodically washed with water and wiped with light oil or wax.
Keep winch in good working order. Damaged or severely-worn parts create
unnecessary dangers and could result in personal injury or property damage.
Original Instructions
READ INSTRUCTIONS CAREFULLY BEFORE ATTEMPTING TO
IMPORTANT SAFETY INFORMATION
This winch has been fully lubricated at the
NOT FOR THE MOVEMENT OF HUMAN BEINGS
Winch is designed to lift load (reel in)
ENGLISH
For maximum
Publicidad
