Okoia UB10 Manual De Instrucciones página 7

OVERVIEW
FITTING THE UNDERBLANKET TO THE BED
1. Spread the underblanket over the mattress.
• Make sure the pillow area is clear.
• The cables of the controller(s) should be
located at the pillow end with the cables
existing from underneath the
underblanket.
• Check that the cables will not be
stretched, pinched or lay in a path where
they could be a trip hazard.
1. Underblanket
2. Mains power cable
3. Mains power cable connector
4. Underblanket connector
5. Tie cord
6. Controller
Note: UB20 has 2 sets of mains
power cables, power
cable/underblanket connectors
and controllers.
The controller has both numeric
and Braille heat markings.
The settings are:
0 OFF
1 Low heat (night use)
2 Medium heat (once bed is warm)
3 High heat (to pre-heat the bed)
EG-5