Publicidad
Idiomas disponibles
Idiomas disponibles
4
NOTE: The cavities in the TIPM specified may be pop
ulated. If so, the existing wires must be removed us
ing a terminal removal kit, or equivalent to install the
fog lamp kit wires.
19. With the fog lamp harness jumper (1) from the kit, in
sert the wire terminals (2, 3) into TIPM connector C11
(4) cavities as follows:
• Jumper harness wire circuit WT/YE (2) cavity 5
(5).
• Jumper harness wire circuit WT/BL (3) cavity 6
(6).
20. Seat the TPA on the face of the TIPM connector C11.
21. Connect TIPM harness connector C11 (3).
NOTE: Make sure the jumper harness is available for
ward of the TIPM.
22. Position the TIPM (1) and install on the three retaining
clips (2). Lift on the TIPM (1) to make sure the retain
ing clips (2) are secure.
23. Connect the fog lamp harness connector (2) to the fog
lamp jumper connector (1) and route the harness (3)
inside the front fender.
Dec 09, 2010
K6859966 Rev. 1
Publicidad
