1
English
before using your Kenwood
before using for the first time
appliance
1 Wash the parts: see 'cleaning'.
●
Read these instructions carefully and
key
retain for future reference.
●
Remove all packaging and any
control switch
labels.
beaker support/interlock
mixing shaft
safety
beaker rest
beaker
general
maximum level
●
Never touch the mixing shaft whilst
minimum level
the appliance is plugged in.
tilting head
●
Keep fingers, hair, clothing and
utensils away from moving parts.
to use your drinks
●
Always unplug:
maker
● ●
before fitting or removing parts
● ●
after use.
1 Make sure the control switch is off
● ●
before cleaning
(O) and then plug into the power
●
Never mix hot ingredients.
supply.
●
Never use a damaged appliance.
2 Place the ingredients into the beaker.
Get it checked or repaired: see
●
The beaker must always be filled to
'service'.
at least the minimum level mark or
●
Never put the appliance in water or
the liquid will not reach the mixing
let the cord or plug get wet - you
shaft. Do not fill above the
could get an electric shock.
maximum level mark or liquid may
●
Never let the cord touch hot
overflow while mixing.
surfaces or hang down where a
3 Place the beaker onto the drinks
child could grab it.
maker, making certain that the
●
Never add ingredients to the beaker
beaker's top edge is behind the
whilst the appliance is operating.
beaker support/interlock and its
●
Only use the appliance with the
bottom edge is on the beaker rest.
beaker supplied.
●
Failure to locate the beaker into the
●
Make sure the beaker is located
beaker support/interlock will prevent
correctly before switching on the
the appliance from operating.
appliance.
●
To assist with the fitting or removal
●
Do not let infirm people use the
of the beaker the drinks maker head
appliance without supervision.
can be tilted upwards
●
Do not let children use or play with
the head during the mixing
the appliance.
operation.
●
Only use the appliance for its intended
4 Move the control switch to the
domestic use. Kenwood will not accept
desired speed. Start mixing on
any liability if the appliance is subject to
speed 1 then increase to speed 2 if
improper use, or failure to comply with
required.
these instructions.
●
Most drinks should be mixed in less
before plugging in
than 2 minutes.
●
Make sure your electricity supply is
5 When mixing is complete, switch off
the same as the one shown on the
the drinks maker, remove the beaker
power handle.
and pour out the drink.
●
This machine complies with
European Economic Community
Directive 89/336/EEC.
2
. Never tilt