Operating Instructions; Care And Maintenance; Troubleshooting; Corrective Action - Kobalt SGY-A13 Manual Del Usuario

OPERATION INSTRUCTIONS
1. Adjust the welding helmet according to
your individual requirements.
Adjust the headband in both diameter and height.
Adjust the angle between the face and helmet
also. The recommended angle is 10° - 12°.
2. On/off.
The solar unit automatically switches on when
exposed to light.

CARE AND MAINTENANCE

Clean the helmet with mild soap in lukewarm water.
Clean the welding filter with a clean, lint-free tissue or cloth.
Do not immerse in water.
If the headband screws (F) should become missing or lost, replace using two M5.6 x 11.5 bolts.

TROUBLESHOOTING

If you have any questions regarding the product, please call cu stomer service at 1-888-3KOBALT,
8 a.m. - 8 p.m., EST, Monday - Friday.
PROBLEM
Irregular
darkening.
Auto-darkening
flickers or does
not darken.
Poor vision.
POSSIBLE CAUSE
1. When assembling the headgear to
the helmet, if one bolt is on the
upside of the hole, another bolt is on
the downside of the hole.
1. Front cover lens is soiled.
2. Photo sensors are dirty.
1. The cover lens and filter cartridges
are not clean.
2. Lighting conditions are too low.
1

CORRECTIVE ACTION

1. Adjust the headband bolts on
both sides to assure they are
both up or both down on the
hole.
1. Clean or replace the front
cover lens.
2. Wipe clean with a soft, lint-free
cloth.
1. Make certain the cover lens and
filter cartridges are clean.
2. Make certain lighting conditions
are not too low.
10