Raider PRO RDP-HD05S Manual Del Usuario página 13

14. Speed setting table.
Operating
Mode
mode switch
Darting
Impact
drilling
Drilling
no impact
Kicking in
fixed
position
the chisel
15. Replace contact brushes. It is best to re-
place the carbon brushes in authorized RAID-
ER repairers.
WARNING! For the longer life of your ma-
chine, follow the manufacturer's instructions.
Before working, pay attention to the instru-
ment's technical characteristics and operat-
ing instructions.
16. Maintenance and service.
16.1. Maintenance and cleaning.
Before carrying out any work on the machine,
disconnect the power supply plug.
To work well and safely, keep the machine and
the ventilation openings clean.
In extremely heavy operating conditions, always
try to use an aspiration system. Flush the ven-
tilation holes frequently and plug the appliance
through a defective safety switch (FI). When
working metals on the inside of the machine, it
is possible to degrade a current-carrying powder.
This may interfere with the protective insulation
of the machine.
16.2. Only allow the repair and maintenance of
the machine to be carried out by qualified spe-
cialists. This ensures the safety of the machine
is maintained.
The hinged protective sleeve should be capable
of self-closing. So keep the area around it clean.
Speed control
Starting Speed
switch regulator
17. Environmental protection.
In order to protect the environment,
the machinery, accessories and
packaging must undergo appropri-
ate treatment for the re-use of the
raw materials contained therein. To
relieve recycling, parts made of artificial materi-
als are appropriately labeled. Do not throw away
machinery at household waste! Under Directive
2012/19 / EC on end-of-life electrical and elec-
tronic equipment and as a national law, machin-
ery that can no longer be used must be separate-
ly collected and processed appropriately for the
recovery of the waste contained therein valuable
secondary raw materials.
13