Important Safety Instructions; Parts List - Tripp-Lite SRWO12US2 Manual Del Propietário

Introduction
Tripp Lite's SRWO12US2 and SRWO16US are perfect open frame rack solutions for applications where space is limited.
Heavy-duty construction and a wall-mount form factor keep equipment out of the way. The swinging door enables easy access
to rack-mounted equipment. The SRWO12US2 and SRWO16US accommodate all standard 19-inch rack-mount equipment,
up to 22 inches deep.

Important Safety Instructions

SAVE THESE INSTRUCTIONS
This manual contains instructions and warnings that must be followed during the installation and operation
of the product described in this manual. Failure to comply may invalidate the warranty and cause property
damage or personal injury.
• Keep the rack in a controlled indoor environment, away from moisture, temperature extremes, flammable liquids and
gasses, conductive contaminants and dust.
• Leave adequate space at the front of the rack for proper ventilation.
• Inspect the shipping container and the rack for shipping damage. Do not use the rack if it is damaged.
• Leave the rack in the shipping container until it has been moved as close to the final installation location as possible.
• Install the rack in a structurally sound area capable of handling the load, the weight of the rack, all equipment that will be
installed in the rack and any other equipment that will be installed nearby.
• Save all packing materials for later use. Repacking and shipping the enclosure without the original packing materials may
cause product damage that may affect the warranty.
• Do not attempt to install the rack unassisted.
• Be sure to use four screws to secure the rack to a 16" on center stud wall using 5/16" minimum diameter lag bolts.
• Never secure the rack to plaster board alone. Always use the studs for these types of walls.
• Be sure to always have one side of the door latched when opening. Failure to do this will cause your equipment to fall out.
• Installation is to be performed by a SKILLED PERSON knowledgeable in mounting cabinets to surfaces intended to be used
in the end use application. It is the installer's responsibility to choose appropriate hardware to mount the cabinet to a
desired surface and be sufficient to support the rated maximum load of 150 lbs.
• Install frame on wall using a level before placing the door on the frame rack.
• Do not attempt to install equipment without first wall-mounting and stabilizing the rack.
• Use of this equipment in life support applications where failure of this equipment can reasonably be expected to cause the
failure of the life support equipment or to significantly affect its safety or effectiveness is not recommended.

Parts List

Wall-Mount Brackets (x2) Front Rail Assembly (x2) Swinging Door Assembly
2
Hex Bolts (x16)