Switching On/Off; Use Automatic Levelling System - Parkside PKLL 8 A2 Traducción Del Manual De Instrucciones Original

Close the battery compartment .
5
Note: when the battery is low, the LED indicator
blinks red.
2
Always replace all batteries at the same time. Only use batteries
from the same manufacturer and with the same capacity.
Remove the batteries from the product if it will not be in use for a
prolonged period of time. In long periods of storage the batteries
can corrode and can run themselves down.

Switching on/off

To switch the product on, push the LOCK switch to the
3
position . Immediately after being switched on, the product
releases two laser lines from the laser beam opening .
7
To switch the product off, push the LOCK switch to the
3
position . When switched off, the pendulum unit is locked.

Use automatic levelling system

To work with automatic levelling, place the product on a level, firm
surface, or fasten it with the - tripod thread to the tripod.
6
When it is switched on, the automatic levelling system automati-
cally corrects irregularities of ±4° within the self levelling area.
The levelling is concluded when the laser lines stop moving and
the LED indicator goes green.
2
If automatic levelling is not possible, e.g. because the base of the
measuring tool deviates by more than 4° from the horizontal or
because the product is being freely hand-held, the LED indicator
will go red and the horizontal and vertical laser lines will be
2
switched off.
GB/IE 31