Descargar Imprimir esta página

Raider RDI-HD50 Manual Del Usuario página 13

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 74
4. Replace drill.
Pull back and release mechanism to hold this position until the download tip.
5. Working with conventional nozzles.
The use of different working ends of the system SDS - Plus requires the use of a conventional chuck
(not included) mounted on a dedicated spindle (suitable for SDS grip).
6. Mounting the chuck to grip. (Fig.)
Mounting the chuck is analogous to 1 "attach a conductor"
7. Installing the plug on conventional chuck (pre-set !!!).
Fix a stationary ring of the chuck and loosen front moving part while the nozzle hole is wide enough to
allow freedom to put the desired tip. After inserting the nozzle back to tighten the chuck moving part while
locking tip. Make sure the nozzle is tight as well pull it along the axis of the machine.
8. Removing the tip of a conventional chuck (pre-set !!!).
Fix the ring loosen the chuck stationary front, while the chuck holes become large enough to allow
freedom to remove the nozzle.
9. Turn the machine.
On - Press power trigger (poz.A)
Off - Free electric trigger (poz.A)
10. Auxiliary handle.
WARNING! Udarniyat breaker RD-HD03 is equipped with a protective system in wedge or pinch
the working tip during operation. However, it is unacceptable use of instruments without MOUNTED
HANDLE MORE!
Auxiliary handle (poz.B) allows safe and stable operation. Setting the position you need done lightly,
simply unscrew the handle, place it in the desired position and retighten.
13

Publicidad

loading