Setting The Time - Silvercrest SR-1300 Manual De Instrucciones

The scan is always performed up to the end of the
frequency band. To launch a scan from the
beginning of the frequency band, press the RESET
button (3).

Setting the Time

The time can only be set while the device is powered
off. If it is still powered on, power the device off by using
the volume control knob (7).
Press and hold the TIME button (1).
Then press the HOUR button (8) repeatedly to set
the hour. You can also keep the HOUR button (8)
pressed down to accelerate the digit adjustment. To
distinguish ante meridian (morning) and post
meridian (afternoon) time, "PM" will display for post
meridian clock hours.
Keep the TIME button (1) pressed. Then press the
MIN button (10) repeatedly to set the minutes. You
can also keep the MIN button (10) pressed down to
accelerate the digit adjustment.
Release the TIME button (1) after the clock has
been set correctly.
Scanradio SR-1300
English - 59