LaTrax RALL 7524 Instrucciones De Instalación

Receiver Box Seal Kit Installation Instructions
A
Wrap the foam seal around the receiver. Do not overlap at this
time.
1. Start at this corner.
C
Install the receiver and receiver box.
(Shown without ESC and
servo wires for clarity)
3. Plug the ESC & servo wires into the
receiver.
2. Fold the antenna over the receiver
before covering it with foam.
DO NOT cut the antenna!
6250 Traxxas Way, McKinney, Texas 75070, Phone: 972-549-3000, Fax: 972-549-3011, Email: support@LaTrax.com
B
Continue to wrap the foam over the ESC and servo wires,
sandwiching them between the layers of foam.
Leave a small gap
between the wires.
Insert ESC wire into wire retainer.
1-888-872-9927
LaTrax.com
Trim excess tape so it
ends flush with corner.
If you have questions or need
technical assistance, call:
(U.S. residents only)
Covers part #7524
KC1839-R01 Rev. 160224