Intended Use; Safety Instructions; Double Insulation; English - Black and Decker H337 Manual De Instrucciones

Intended use

Your Black & Decker food chopper has been designed for
chopping, beating and mixing food and beverage ingredients.
This product is intended for household use only.

Safety instructions

Warning! When using mains-powered appliances, basic
N
safety precautions, including the following, should always
be followed to reduce the risk of fire, electric shock and
personal injury.
Read this entire manual carefully before using the appliance.
N
The intended use is described in this manual. The use of
N
any accessory or attachment or the performance of any
operation with this appliance other than those
recommended in this instruction manual may present a
risk of personal injury.
Retain this manual for future reference.
N
Using your appliance
Make sure that the appliance is switched off before
N
connecting to or disconnecting from the power supply.
Always take care when using the appliance.
N
Do not use the appliance outdoors.
N
Always protect the motor unit from water or excessive
N
humidity.
Do not operate the appliance if your hands are wet.
N
Do not operate the appliance if you are barefoot.
Do not touch moving parts. Keep long hair and loose
N
clothing out of the way of the moving parts.
Guide the power supply cord neatly so it does not hang
N
over the edge of a worktop and cannot be caught
accidentally or tripped over.
Never pull the power supply cord to disconnect the plug
N
from the socket. Keep the power supply cord away from
heat, oil and sharp edges.
Switch off and wait for the motor to stop running before
N
disconnecting the appliance from the power supply.
Never detach any part or accessory while the appliance is
N
still connected to the power supply. Always disconnect
the appliance from the power supply first.
If the power supply cord is damaged during use,
N
disconnect the appliance from the power supply
immediately. Do not touch the power supply cord before
disconnecting from the power supply.
Disconnect the appliance from the power supply when not
N
in use, before fitting or removing parts and before cleaning.
Safety of others
Do not allow children or any person unfamiliar with these
N
instructions to use the appliance.
Do not allow children or animals to come near the work
N
area or to touch the appliance or power supply cord.
Close supervision is necessary when the appliance is
used near children.
After use
Switch off and remove the plug from the socket before
N
leaving the appliance unattended and before changing,
cleaning or inspecting any parts of the appliance.
When not in use, the appliance should be stored in a dry
N
place. Children should not have access to stored appliances.
Inspection and repairs
Before use, check the appliance for damaged or defective
N
parts. Check for breakage of parts, damage to switches
and any other conditions that may affect its operation.
Do not use the appliance if any part is damaged or defective.
N
Have any damaged or defective parts repaired or replaced
N
by an authorised repair agent.
Before use, check the power supply cord for signs of
N
damage, ageing and wear.
Do not use the appliance if the power supply cord or
N
mains plug is damaged or defective.
If the power supply cord or mains plug is damaged or
N
defective it must be repaired by an authorised repair
agent in order to avoid a hazard. Do not cut the power
supply cord and do not attempt to repair it yourself.
Never attempt to remove or replace any parts other than
N
those specified in this manual.

Double insulation

This appliance is double insulated in accordance
with EN 60335; therefore no earth wire is required.
Always check that the power supply corresponds to
the voltage on the rating plate.
To avoid the risk of electric shock, do not immerse
the cord, plug or motor unit in water or other liquid.
Features
1. Speed control switch
2. Bowl
3. Lid
4. Chopper blade
Assembly
Warning! Before assembly, make sure that the appliance is
switched off and unplugged.
Fitting and removing the bowl (fig. A)
Place the bowl (2) on the pin (7), aligning the lugs (8) with
N
the recesses (9).

ENGLISH

3