Assembly Instructions - Adventuridge 93410416 Manual Del Usuario

IMPORTANT: WE ADVISE YOU TO ASSEMBLE THE
TENT ONCE BEFORE GOING CAMPING TO BECOME
FAMILIAR WITH THE ASSEMBLY OF THE TENT.
NOTE: PLEASE LOOK AT THE REPLACEMENT
PARTS DIAGRAM TO SEE HOW YOUR FRAME IS
ASSEMBLED.
TO PROLONG THE LIFE OF THE TENT FLOOR,
SELECT A LEVEL, CLEAN AREA FOR THE CAMPSITE.
TO PREVENT DAMAGE TO THE ZIPPER, UNZIP THE
DOORS TO ALLOW AIR TO ENTER THE TENT.
TO IMPROVE THE WEATHER RESISTANCE OF YOUR
TENT, IT IS ADVISABLE TO USE SEAM SEALER TO
COAT ALL EXPOSED SEAMS. YOU SHOULD APPLY
ONLY TO THE INSIDE SEAMS OF THE TENT AND
UNDERSIDE OF THE TENT FLY. IF APPLIED TO THE
OUTSIDE OF SEAMS, DISCOLORATION OF YOUR
TENT MAY OCCUR. SEAM SEALER IS AVAILABLE IN
THE CAMPING SECTION OF ANY LOCAL SPORTING
GOODS STORE.
STEP 1: Spread tent out flat, floor side down.
STEP 2: Extend the fiberglass frame poles by pulling out each section
and placing ends into the metal ferrule connectors. You will have three
poles. The two longer poles are the tent poles (A) and the one shorter
pole is for the fly (B).
STEP 3: Slide each fiberglass tent pole (A) through the sleeves on the
top of the tent roof.
Lay the fiberglass frame sections across the tent forming an "X".
Straighten sleeves along the fiberglass frame pole sections.
STEP 4: Starting at the back corners of the tent, place ends of the
fiberglass poles over the metal pins located at each corner of the tent.
To raise tent, repeat the same procedure at the front corners of the tent,
flex the fiberglass poles into an upward position, forming two arches.
STEP 5: Locate the fabric ties attached to the center of the tent roof
and tie around the fiberglass sections
STEP 6: Stake down tent by inserting tent stakes through the metal
rings at each corner of the tent. Hammer stakes into ground at a 45°
angle, by using a hammer or mallet. Make sure to pull tent out even and
tight.
Tent should appear as shown.

Assembly Instructions

5