Black and Decker MTTS7 Manual De Instrucciones página 5

d. Never hold piece being cut in your hands or
across your leg. Secure the workpiece to a
stable platform. It is important to support the
work properly to minimize body exposure,
blade binding, or loss of control.
e. Hold the power tool by insulated gripping
surfaces only, when performing an
operation where the cutting tool may
contact hidden wiring or its own cord.
Contact with a "live" wire will also make
exposed metal parts of the power tool "live"
and could give the operator an electric shock.
f. When ripping, always use a rip fence or
straight edge guide. This improves the
accuracy of cut and reduces the chance of
blade binding.
g. Always use blades with correct size and
shape (diamond versus round) of arbour
holes. Blades that do not match the mounting
hardware of the saw will run eccentrically,
causing loss of control.
h. Never use damaged or incorrect blade
washers or bolt. The blade washers and bolt
were specially designed for your saw, for
optimum performance and safety of operation.
When cutting pipe or conduit, make sure that
u
they are free from water, electrical wiring, etc.
(Original instructions)
Do not touch the workpiece or the blade
u
immediately after operating the tool. They can
become very hot.
Be aware of hidden hazards, before cutting into
u
walls, floors or ceilings, check for the location
of wiring and pipes.
The blade will continue to move after releasing
u
the switch. Always switch the tool off and
wait for the saw blade to come to a complete
@ standstill before putting the tool down.
Warning! Contact with, or inhalation
of dusts arising from cutting applica-
tions may endanger the health of the
operator and possible bystanders.
Wear a dust mask specifically
designed for protection against dust
and fumes and ensure that persons
within or entering the work area are
also protected.
Always wear hearing protection when working
u
with powered saws
ENGLISH
5