FCC STATEMENT
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two co
nditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause unde
sired operation.
2. Changes or modifications not expressly approved by the party responsible for compliance coul
d void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, p
ursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection a
gainst harmful interference in a residential installation. This equipment generates, uses and can r
adiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that in
terference will not occur in a particular installation. If this equipment does cause harmful interfer
ence to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following mea
sures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is c
onnected.
—Consult the dealer or an experienced radio/ TV technician for help.
This device is slave equipment, the device is n ot radar detection and not ad‐hoc operation in
The DFS band.
The device for operation i n the band 5150‐5250MHz is o nly for indoor use to reduce the
potential for harmful interference to co‐channel mobile satellite systems;
The maximum antenna gain permitted for devices in the bands 5250‐5350MHz and
5470‐5725MHz shall be such that the equipment still complies with the e.i.r.p. limit;
The maximum antenna gain permitted for devices in the band 5725‐5850MHz shall be
Such that the equipment still complies with the e.i.r.p. limits specified for point‐to‐point and
non‐point‐to‐point operation a s appropriate; and t he worst‐case t ilt angle(s) necessary to
Remain compliant with the e.i.r.p. elevation mask requirement set forth in
Section 6.2.2(3) shall be clearly indicated.
Users should also be advised that high‐power radars are allocated as primary users
(i.e. priority users) of the bands 5250‐5350MHz and 5650‐5850MHz and that these
Radars could cause interference and/or d amage to LE‐LAN devices.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environ
ment. In order to avoid the possibility of exceeding the FCC radio frequency exposure limits, Hum
an proximity to the antenna shall not be less than 20cm (8 inches) during normal operation.